E4726 Cmd Rej: Linkset Type for Network/Cluster Route can't be PRX

For the chg-dstn command, if the specified destination point code is a cluster or network destination point code, then the specified routeset cannot contain a route over proxy linksets.

For the ent/chg-rte commands, if a proxy linkset is used, then the value specified for the dpc parameter cannot be a network cluster address (ni-nc-*) or network address (ni-*-*).

Recovery - chg-dstn

1. Determine whether the DPC is a cluster point code. Enter the rtrv-dstn command.
2. Display the proxy linksets. Enter the rtrv-ls:lst=prx command.
3. Revise the data as necessary. Refer to the Database Administration - SS7 User's Guide for assistance.
4. Re-enter the command that generated this error message, specifying a valid combination of parameters. Refer to the command description in Commands User's Guide and to the Database Administration - SS7 User's Guide for assistance.

   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).

Recovery - ent/chg-rte

1. Display the proxy linksets. Enter the rtrv-ls:lst=prx command.
2. Revise the data as necessary. Refer to the Database Administration - SS7 User's Guide for assistance.
3. Re-enter the command that generated this error message, specifing a valid combination of parameters. Refer to the command description in Commands User's Guide and to the Database Administration - SS7 User's Guide for assistance.

   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).