E4806 Cmd Rej: TPS exceeded allowed range

The maximum allowed TPS values for E5-ENET, E5-ENET-B, or SLIC cards are:

• E5-ENET - 5000 TPS
• E5-ENET-B or SLIC when the E5-ENET-B IPSG High Throughput Capacity feature is turned off - 6500 TPS
• E5-ENET-B or SLIC when the E5-ENET-B IPSG High Throughput Capacity feature is turned on - 9500 TPS

Recovery

1. Display the card types in the system. Enter the rtrv-card command.
2. Display the status of the E5-ENET-B IPSG High Throughput feature. Enter the rtrv-ctrl-feat command.
   If the feature does not appear in the output, then the feature is not enabled. If the feature has a status of OFF, then the feature is enabled but is not turned on.
3. Install E5-ENET-B or SLIC cards as necessary. Refer to the Hardware Reference and Installation Guide for assistance.
4. Turn the E5-ENET-B IPSG High Throughput feature on as necessary. Refer to the Database Administration - IP7 User's Guide for assistance.
5. Re-enter the ent/chg-ls command that generated this error message.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).