E3681 Cmd Rej: Source and destination combination is not allowed

For the act-upgrade command, if the dest=remove parameter is specified, then the src=fixed and src=usb parameters cannot be specified.

Caution:

It is strongly recommended that the act-upgrade command be used only in conjunction with the system Upgrade Procedure for your target release. The Upgrade Procedure provides step-by-step information on performing an upgrade.

For the copy-gpl command, GPLs can be copied only as follows:

• From the fixed disk on the active TDM to the removable drive
• From the removable drive to the fixed disk on the standby TDM
• From the active TDM to the standby TDM
• From the standby TDM to the removable drive

The active TDM cannot be the destination.

Recovery

Re-enter the command that generated this error message, specifying a valid combination of parameters. Refer to the command description in Commands User's Guide for assistance.

Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).