E5415 Cmd Rej: Feature can not be enabled with non-SMXG VSCCP in system

For the chg-stpopts command, the ANSIGFLEX option can not be turned ON if DSM is equipped in the system and one or more following feature are Enabled.

• 1100 TPS/DSM for ITU NP
• Port
• AINPQ
• ATINP
• EIR
• G-Flex MAP Layer Routing
• G-Port
• Info Analyzed Relay Base
• INP
• IS41 GSM Migration
• Prepaid Short Message Intercept Phase 1 (PPSMS)
• MO SMS ASD
• MO SMS GRN
• MO SMS IS41-to-GSM Migration
• MO-based GSM SMS NP
• MO-based IS41 SMS NP
• Portability Check for MO SMS
• TIF Number Portability
• TIF Number Substitution
• TIF Subscriber CgPN Blacklist
• V-Flex
• TIF Selective Screening

For the enable-ctrl-feat command, the following features can not be enabled if the ANSIGFLEX system option is ON (see the rtrv-stpopts command) and a DSM is equipped in the system.

• 1100 TPS/DSM for ITU NP
• ANSI-41 INP Query (AINPQ)
• A-Port
• ATINP
• Equipment Identity Register (EIR)
• G-Flex MAP Layer Routing
• G-Port
• Info Analyzed Relay Base
• INP
• IS41 GSM Migration (IGM)
• MO SMS ASD
• MO SMS GRN
• MO SMS IS41-to-GSM Migration
• MO-based GSM SMS NP
• MO-based IS41SMS NP
• Portability Check for MO SMS
• TIF Number Portability
• TIF Number Substitution
• TIF Subscriber CgPN Blacklist
• V-Flex

Recovery

1. Enter the rept-stat-card:mode=full:loc=<Service Module card location> command to display the card type in the system.
2. Remove DSM card(s) and replace with either E5-SM4G or E5-SM8G-B card(s) as necessary. Refer to the Maintenance Guide for assistance.
3. Re-enter the command that generated this error message. Refer to the command description in Commands User's Guide for assistance.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).