E3739 Cmd Rej: No Entry found

The value specified for the host parameter must already exist in the IP Host table.

For the chg-assoc and ent-assoc commands, RHOST is not present in the IPHOST table.

For the chg/dlt-ip-conn command, the value specified for the CNAME parameter must already exist in the IPCONN table.

For the chg/dlt/rtrv-enum-prof command, the specified profile name must be present in the ENUM Profile Table.

For the dlt/rtrv-enum-acl command, the IP address specified by the IPADDR/IPADDR6 parameter must be provisioned in the ENUM ACL Table.

For the dlt/rtrv-enum-profsel command, the value specified for the ENTITYID, SDN or EDN must already exist in the ENUM Profile Selection Table or the ENUM DN Block Table respectively.

Recovery - Non-ENUM commands:

1. Display the existing entries in the IP Host table. Enter the rtrv-ip-host command.

   Host names are shown in the HOST field.

2. Re-enter the command that generated this error message, specifying a valid combination of parameters.

   Refer to the command description in Commands User's Guide and to Database Administration - IP7 User's Guide for assistance.

Recovery - ENUM commands:

1. Use the rtrv-enum-prof, rtrv-enum-acl, or rtrv-enum-profsel command to display the entries in the ENUM Profile Table, ENUM ACL Table, ENUM Profile Selection Table, or the ENUM DN Block Table.
2. Re-enter the command that generated this error message, specifying a valid combination of parameters.

   Refer to the command description in Commands User's Guide for assistance.

Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).