E3683 Cmd Rej: TLNP feature must be ON

For the chg-gws-actset command, the Triggerless LNP Feature (TLNP) must be turned on before a value of tlnp can be specified for the act1 - act10 parameters.

For the chg-lnpopts command, the TLNP feature must be turned on before the jipprv or jipdigits parameter can be specified.

Note:

Once a feature that is controlled using a feature bit has been turned on, it cannot be turned off.

Recovery

1. Display the status of the TLNP feature. Enter the rtrv-feat command.
2. Turn on the TLNP feature if necessary. Refer to the ELAP Administration and LNP Feature Activation Guide for assistance.
3. Re-enter the command that generated this error message.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).