Introduction

This chapter describes the procedures needed to add, remove, or change global title translation (GTT) data in the database

The items configured in this section are:

• Translation types
• Global title translations.

The following items must also be configured for the Global Title Translation feature. The procedures to configure these items are located in the Global Title Translation (GTT) Overview section.

• Service modules
• Translation type mapping
• Concerned signaling point codes
• Mate applications
• Mated relay node groups
• GT Conversion Table Entries for the ANSI/ITU SCCP Conversion feature.
• Loopsets for the SCCP Loop Detection feature.
• GT modification identifiers for the Advanced GT Modification feature.

The procedures shown in this chapter use a variety of commands. For more information on these commands, refer to Commands User's Guide.

Note:

1. Before turning the Global Title Translation (GTT) feature on with the chg-feat:gtt=on command, make sure you have purchased this feature. If you are not sure whether you have purchased the GTT feature, contact your Oracle Sales Representative or Account Representative.
2. To perform the procedures in this chapter, the GTT feature must be on. The translation type (ent-/dlt-/rtrv-tt) and the GTT (ent-/dlt-/chg-/rtrv-gtt) commands can be executed when the EGTT feature is turned on, but will only produce CDGTA GTT sets and CDGTA GTT selectors. For more details on the EGTT feature, refer to the Enhanced Global Title Translation (EGTT) Configuration section.
3. To find out about the differences between the Global Title Translation (GTT) feature and the Enhanced Global Title Translation (EGTT) feature, refer to the Upgrading from Global Title Translation (GTT) to Enhanced Global Title Translation (EGTT) section.