ATM High-Speed Signaling Link Configuration

An ATM high-speed signaling link is configured using these commands:

• ent-card - Used to add the either the ANSIATM or E1ATMLIMs
• ent-slk - Used to add the signaling link
• chg-atm-lps - Used to change the ATM signaling link parameters. The ATM signaling link parameters control the behavior of the ATM high-speed signaling links. These parameters are not configured with the ent-slk command and are assigned default values when the ATM high-speed signaling link is added to the database.

To configure an ATM high-speed signaling link, perform these procedures:

• Adding an ATM High-Speed LIM
• Adding an ATM High-Speed Signaling Link
• Changing an ATM High-Speed Signaling Link Parameter Set .

Procedures for configuring the linksets and routes, and for removing SS7 signaling links (which includes ATM high-speed signaling links), are contained in SS7 Configuration. The procedure for removing the LIM containing the ATM high-speed signaling link is contained in the Database Administration Manual - System Management. These procedures contain no information that is specific to ATM high-speed signaling links, therefore, are not included in this appendix.

The procedures contained in this appendix use a variety of commands. If more information on these commands is needed, go to the Commands Manual to find the required information.