0561 - Can't Establish Hi Bit Rate; All HW OK

This message is issued if the system cannot establish high bit rate operation when it is equipped with HIPR2 cards at all MUX locations and the HIPR2 High Rate Mode feature is ON.

Note:

This UAM might appear during transition phase when the HIPR2 High Rate Mode feature status has changed, but eventually it will be cleared if high bit rate is established on both IMT buses.

Example

RLGHNCXA21W 09-02-07 12:01:43 EST  EAGLE 41.1.0
*C  5025.0561 *C SYSTEM            Can't establish Hi Bit rate;All HW OK

Alarm Level: Critical

Recovery

1. Verify the status of the cards using the command: rept-stat-mux.
   Example of the output:

   CARD   TYPE       PST            SST        AST       BITRATE   BITRATE
                                                         (OPER)    (ACT)
   ------------------------------------------------------------------------
   1109   HIPR2      IS-ANR         Restrict   -----     HIGH      LOW
   1110   HIPR2      IS-NR          Active     -----     HIGH      HIGH
   1209   HIPR2      IS-ANR         Restrict   -----     HIGH      LOW
   1210   HIPR2      IS-NR          Active     -----     HIGH      HIGH
   1309   HIPR2      IS-ANR         Restrict   -----     HIGH      LOW
   1310   HIPR2      IS-NR          Active     -----     HIGH      HIGH
   Command Completed.

2. Replace any faulty HIPR2 cards with a new HIPR2 card.
   Refer to the Maintenance Manual, Appendix A, Card Removal/Replacement Procedures for information on replacing the HIPR2 cards.
3. If the alarm does not clear, contact My Oracle Support (MOS).