0189 - 1114-SHS, 1116-PHS, 1116-SHS Clocks Failed

This message indicates the following High Speed clocks failed:

• The secondary High Speed clock for the TDM card in slot 1114

• The primary High Speed clock for the TDM card in slot 1116

• The secondary High Speed clock for the TDM card in slot 1116

Example

station1234 99-03-05 16:28:08 EST  EAGLE 31.6.0 
** 0052.0189 ** HS CLOCK SYSTEM  1114-SHS, 1116-PHS,1116-SHS clocks failed

Alarm Level: Major

Recovery

1. Use the rept-stat-clk command to determine the current clock configuration.
   Example of the output:

   rept-stat-clk
       Command entered at terminal #3.
   ;
       tekelecstp 99-03-05 13:34:15 EST EAGLE 31.6.0
       CARD LOC= 1114 (Active   )       CARD LOC= 1116 (Isolated )
       PRIMARY BITS      = Active        PRIMARY BITS      = -----
       SECONDARY BITS    = Idle          SECONDARY BITS    = -----
       HS PRIMARY CLK    = Active        HS PRIMARY CLK    = -----
       HS SECONDARY CLK  = Idle          HS SECONDARY CLK  = -----
       HS CLK TYPE       = E1 UNFRAMED   HS CLK TYPE       = -----
       HS CLK LINELEN    = SHORTHAUL     HS CLK LINELEN    = -----
                                        PST           SST       AST
       SYSTEM CLOCK                     IS-NR         ACTIVE    ALMINH 
       ALARM STATUS     = No Alarms. 
       # Cards using CLK A = 009        # Cards with bad CLK A = 000
       # Cards using CLK B = 000        # Cards with bad CLK B = 009
       # Cards using CLK I = 000
                                        PST           SST       AST
       HS SYSTEM CLOCK                  IS-NR         ACTIVE    ALMINH 
       ALARM STATUS     = No Alarms. 
       # Cards using HSCLK A = 001      # Cards with bad HSCLK A = 000
       # Cards using HSCLK B = 000      # Cards with bad HSCLK B = 002
       # Cards using HSCLK I = 000
       Command Completed.

2. Follow local procedures to troubleshoot and repair the E1/T1 High Speed clocks.
3. If one of the reference clocks is still not functioning, replace the TDM card(s).
   Refer to the Maintenance Manual, Appendix A, Card Removal/Replacement Procedures.