Adding a Path Topology Hiding Configuration Set

Use this task to create a new Path Topology Hiding Configuration Set.

For more information about the fields, see Diameter Topology Hiding Path Topology Hiding Configuration Set Elements.

1. Click Diameter > Configuration > Topology Hiding > Path Topology Hiding Configuration Sets.
2. Click Insert.

   Note:

   If the maximum number of Configuration Sets allowed in the system (500) has been configured, then the Path Topology Hiding Configration Sets page does not open.
3. Enter a unique name for the Configuration Set in the Path Topology Hiding Configuration Set Name field.
4. Enter a suffix for the Hostname in the Hostname Suffix field.
5. Enter a value to be used when replacing the Route-Record headers in the Route-Record Pseudo Hostname field.
6. Enter a value to be used when replacing the host name in the Proxy-Host AVP in the Proxy-Host Pseudo Hostname field.
7. Enter an encryption key value in the Encryption Key field.
8. Click:
   • OK to save the new Configuration Set and return to the Path Topology Hiding Configuration Sets page.
   • Apply to save the changes and remain on this page.
   • Cancel to return to the Path Topology Hiding Configuration Sets page without saving any changes.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • Any required field is empty (no value was entered).
   • The value in any field is not valid or is out of range.
   • The Path Topology Hiding Configuration Set Name is not unique; it already exists in the system.