Inserting an Address Resolution

Use this task to add a new Address Resolution.

Before this task is performed, make sure there is at least one supported Diameter application configured in the system.

1. Click FABR > Configuration > Address Resolutions.
2. Click Insert.
3. Select the Application ID from the list.

   Note:

   The Application IDs presented in this list are those created using FABR > Configuration > Applications.
4. Select the Command Code from the list.

   Note:

   The Command Codes presented in this list are those created using Diameter > Command Codes.
5. For the Primary Routing Entity section, perform the following:
   1. Select the Routing Entity from the list.
   2. Select the Primary AVP from the list.
   3. If needed, select the Secondary AVP from the list.
   4. Select the type of destination from the Destination Type list.
   5. Check the Prefix Search Enabled checkbox to perform the IMSI/MSISDN prefix based lookup.
   6. Check the Blacklist Search Enabled checkbox to perform the IMSI/MSISDN blacklist lookup.
   7. Check the FallBack Search Enabled checkbox to perform the Domain-Identifier lookup.
6. If needed, for the Secondary Routing Entity section, perform the following:
   1. Select the appropriate Routing Entity type from the Routing Entity Type list.
   2. Select the Primary AVP from the Primary AVP list.
   3. If needed, select the Secondary AVP from the Secondary AVP list.
   4. Select the type of destination from the Destination Type list.
   5. Check the Prefix Search Enabled checkbox to perform the IMSI/MSISDN prefix based lookup.
   6. Check the Blacklist Search Enabled checkbox to perform the IMSI/MSISDN blacklist lookup.
   7. Check the FallBack Search Enabled checkbox to perform the Domain-Identifier lookup.
7. If needed, for the Tertiary Routing Entity section, perform the following:
   1. Select the appropriate Routing Entity type from the Routing Entity Type list.
   2. Select the Primary AVP from the Primary AVP list.
   3. If needed, select the Secondary AVP from the Secondary AVP list.
   4. Select the type of destination from the Destination Type list.
   5. Check the Prefix Search Enabled checkbox to perform the IMSI/MSISDN prefix based lookup.
   6. Check the Blacklist Search Enabled checkbox to perform the IMSI/MSISDN blacklist lookup.
   7. Check the FallBack Search Enabled checkbox to perform the Domain-Identifier lookup.
8. Click OK, Apply, or Cancel.