1. Virtual Signaling Transfer Point
  2. GUI Configurations
  3. Configuration
  4. CAT2 GTA

5.1.48 CAT2 GTA

A CAT2 GTA is an entity which are used to perform Category 2 securiry check for GTA based. It will be used for IR21 upload feature.

Select the VSTP, and then Configuration, and then CAT2 GTAs page. The page displays the elements on the CAT2 GTAs View, Insert, and Edit pages.

Note:

Data Input Notes apply to the Insert and Edit pages only; the View page is read-only.

Table 5-48 CAT2 GTAs Elements

Element Description Data Input Notes
TA Digit code Name of TA Digit code. Valid names are strings between one and 5 characters, inclusive. Valid characters are alphanumeric. The name must contain at least one alpha and must not start with a digit.
Sender TA Digit code Name of Sender TA Digit code. Valid names are strings between one and 5 characters, inclusive. Valid characters are alphanumeric. The name must contain at least one alpha and must not start with a digit.
Start Global Title Address Defines the start of a range of this Global Title Address.  
End Global Title Address End global title address. This parameter specifies the end of a range of global title digits.  
Node Type Type Of Node Valid values are: HLR, MGT

You can perform add, edit, or delete tasks on VSTPConfigurationCAT2 GTAs page.

Adding a CAT2 GTA

Perform the following steps to configure a new CAT2 GTA:

  1. Click Insert.

    Note:

    The new CAT2 GTA must have a name that is unique across all CAT2 GTAs at the SOAM. In addition, the CAT2 GTA's IP Port combination must also be unique across all CAT2 GTAs configured at the SOAM.
  2. Enter the applicable values.
  3. Click OK, Apply, or Cancel

Editing a CAT2 GTA

Use this procedure to change the field values for a selected CAT2 GTA. (The CAT2 GTA Name field cannot be changed.):
  1. Select the CAT2 GTA row to be edited.
  2. Click Edit
  3. Enter the updated values.
  4. Click OK, Apply, or Cancel

Deleting a CAT2 GTA

Use the following procedure to delete a CAT2 GTA.

Note:

You cannot delete a CAT2 GTA if it is part of the configuration of one or more Linksets.
  1. Select the CAT2 GTA to be deleted.
  2. Click Delete.
  3. Click OK or Cancel.