The Primavera uClient Configurator allows you to create and maintain a connection to Primavera Unifier from your desktop and to create connections to different Primavera Unifier environments.
To set up the uClient Configurator, you must complete the following sequential steps:
- Install the Primavera uClient Configurator
- Create, or edit, a connection
- Set up proxy information
Units of Measure
Unifier supports the “Sq Ft” (Square Foot) and “Sq Meter” (Square Meter) units, as default units.
If you want to use any other units of measure in AutoCAD versions 2015, 2016, and 2017, you must configure those units in Unifier by following these steps:
- In Unifier, go to your Company Workspace tab, Data Structure Setup node, and click Data Definitions sub-node to expand.
- Click Basic.
- Click Find, search for "SYS Space Unit of Measure," and open it. The Modify Data Definition window opens.
- Click the Data Set tab, click Add and add your units.
Example
If you are using inches as unit of measure in AutoCAD, then add the unit by entering "Sq Inches" as the value and label.
Units in AutoCAD | Units in Unifier Setup |
|---|---|
Inches | Sq Inches |
Feet | Sq Ft |
Miles | Sq Miles |
Millimeters | Sq Millimeters |
Centimeters | Sq Centimeters |
Meters | Sq Meter |
Kilometers | Sq Kilometers |
Microinches | Sq Microinches |
Mils | Sq Mils |
Yards | Sq Yards |
Angstroms | Sq Angstroms |
Nanometers | Sq Nanometers |
Microns | Sq Microns |
Decimeters | Sq Decimeters |
Dekameters | Sq Dekameters |
Hectometers | Sq Hectometers |
Gigameters | Sq Gigameters |
Astronomical Units | Sq Astronomical Units |
Light Years | Sq Light Years |
Parsecs | Sq Parsecs |