Configuring Integration Broker Service Target Locations

To configure service target locations:

1. Select PeopleTools > Integration Broker > Configuration > Service Configuration.

   See Using the Service Configuration Page to Set Service Configuration Properties.

2. Click the Setup Target Locations link.

3. Enter a value for the target location or locations pointing to the appropriate Integration Broker gateway connector:

   Image: Target Locations page

   This example illustrates the fields and controls on the Target Locations page.

   

   • If you plan to use basic authentication only and Secure Sockets Layer (SSL) has not been configured on your system, then enter a value in the Target Location field only.

   • If you plan to use secure authentication and SSL has been configured on your system, then enter a value in the Target Location field and in the Secure Target Location field.

   Important! You should use the secure authentication approach.

   If you specify both target locations, then the secure target location is always used for access to feeds.

   For more information on setting up SSL, see Implementing WebLogic SSL Keys and Certificates.

4. Click the OK button.

5. On the Service Configuration page, click the Save button to save the configuration.