Validate Gate Conditions Manually (Refresh)

You can manually validate conditions, which is the same validation that is performed during scheduled runs. The dashboard is updated to show any changes to the gates conditions.

Note: Your Administrator can configure the gates setup so that conditions are validated on each gates run.

To validate conditions manually:

  1. Go to the shell tab and switch to User mode.
  2. In the left Navigator, select Gates.
  3. In the upper section of the Gates dashboard, click Actions, and then select Refresh.

If a gates condition is met, the condition is marked as Complete. If all gates conditions are found to have been met for a project/shell phase (and if Automatic Advancement is Yes), the project/shell phase advances to the next phase.


Last Published Monday, April 14, 2025