22003 - Application ID Mismatch with Peer
- Event Type:
- DIAM
- Description:
- While attempting to route a request message to a
peer, a peer's transport connection was bypassed because the peer did not
support the Application ID for that transport connection.
- Severity:
- Info
- Instance:
- <MPName>
- HA Score:
- Normal
- Throttle Seconds:
- 10
- OID:
- eagleXgDiameterApplicationIdMismatchWithPeerNotify
Recovery:
-
The system's peer routing table may be using a Route
List containing a peer which does not support the Application ID or the list of
Application IDs supported by the peer on each connection may not be the same.
The list of Application IDs that the peer supports on each connection can be
viewed as follows:
-
Navigate to the GUI page:
Diameter > Maintenance >
Connections
-
Locate the relevant Peer Node and check the
supported Application IDs.
-
If Application IDs are not the same for each
connection (but should be) the Application ID for any connection can be
refreshed by:
-
Navigate to the GUI page: Diameter > Maintenance > Connections
-
Locate the relevant
Connection
-
Disable the
Connection
-
Enable the
Connection
-
The Diameter Node which originated the message
(identified by the Origin-Host AVP) could be configured incorrectly and the
application is trying to address a node which doesn't support the Application
ID. This cannot be fixed using this application.
-
If the problem persists, contact
unresolvable-reference.htm#GUID-DD0927BD-FD0B-4CEB-86E9-98A33C12D4E0.