Adding a Protected Network

Use this task on the NOAM to create a new Protected Network.

The fields are described in Diameter Protected Network configuration elements.

1. Click Diameter > Configuration > Topology Hiding > Protected Networks.
2. Click Insert.
3. Enter a unique name in the Protected Network Realm field to identify the Protected Network.
4. Select a Trusted Network List for the Protected Network, if required.
5. Select a Configuration Set for each required type of Topology Hiding:
   • Path Topology Hiding Configuration Set
   • S6a/S6d HSS Topology Hiding Configuration Set
   • MME/SGSN HSS Topology Hiding Configuration Set
   • S9 PCRF Topology Hiding Configuration Set
   • S9 AF/pCSCF Topology Hiding Configuration Set
6. Click OK, Apply, or Cancel.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • Any required field is empty; no value was entered or selected
   • The entry in any field in not valid (wrong data type or out of the valid range)
   • The Protected Network Realm is not unique; it already exists in the system
   • Adding this Protected Network would exceed the maximum number of Protected Networks (500) allowed in the system