Editing Traffic Throttle Groups

Use this task to edit an existing Traffic Throttle Group.

When the Traffic Throttle Groups page opens, the fields are populated with the currently configured values.

The Traffic Throttle Point Groups Name cannot be edited.

The fields are described in Diameter Traffic Throttle Groups elements.

1. Click Diameter > Configuration > Traffic Throttle Groups.
2. Select the Traffic Throttle Point Group to edit.
3. Click Edit.
4. Update the relevant fields.
5. Click OK, Apply, or Cancel.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • The selected Traffic Throttle Group no longer exists; it has been deleted by another user.
   • Any field is empty (no value was entered).
   • If you attempt to update a TTG and mark it as shared, but the NOAM is not accessible.
   • If you attempt to mark the shared TTG to non-shared when it is already being used by a Route List configured on another DSR within this network.
   • The value in any field is not valid or is out of range.