Traffic Throttle Point Configuration Sets

A TTP Configuration Set defines a set of configuration attributes for a TTP, and can be assigned to one or more TTPs.

You can modify any of the TTP Configuration Sets attributes while the TTP is enabled for service (Throttling Admin State is Enabled).

You can perform these tasks on an Active System OAM (SOAM).

You can perform the following actions for Traffic Throttle Point Configuration Sets:

• Filter the list of Traffic Throttle Point Configuration Sets to display only the desired Traffic Throttle Point Configuration Sets.
• Sort the list by column contents in ascending or descending order by clicking the column heading. The default order is by Traffic Throttle Point Configuration Set Name in ascending ASCII order.
• Click Insert.

  On the Traffic Throttle Point Configuration Sets [Insert] page, you can add a new Traffic Throttle Point Configuration Set. See Adding Traffic Throttle Point Configuration Sets.

  If the maximum number of Traffic Throttle Point Configuration Sets already exists in the system, an error message displays.

• Select a Traffic Throttle Point Configuration Set Name in the list. Click Edit to display the Traffic Throttle Point Configuration Sets [Edit] page and edit the selected Traffic Throttle Point Configuration Set.

  See Editing Traffic Throttle Point Configuration Sets.

  If no Name is selected, Edit is disabled.

• Select a Traffic Throttle Point Configuration Set Name in the list and click Delete to remove the selected Traffic Throttle Point Configuration Set.

  The default Traffic Throttle Point Configuration Set can be edited, but cannot be deleted. See Deleting Traffic Throttle Point Configuration Sets.