Adding a Route List

Use this task to create a new Route List. The fields are described in Diameter Route List configuration elements.

Note:

You must have at least one Route Group configured before you can create a Route List.

1. Click Diameter > Configuration > Route Lists.
2. Click Insert.
3. Enter a unique name for the Route List in the Route List Name field.
4. Enter the Minimum Route Group Availability Weight in the field.
5. Enable or disable routing across alternate Route Groups in Route List by setting Route Across Route Groups.
6. Select one to three Route Groups from the Route Group lists. For each Route Group you specify, select a Site Name, Traffic Throttle Group, and Maximum Loss Percent Threshold.
   The Site Name list includes the local SOAM (assuming that at least one TTG has been configured).

   Note:

   Traffic Throttle Group is disabled until a Site Name is selected.
7. Click OK, Apply, or Cancel.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • Any required field is empty; no value was entered or selected
   • The entry in any field in not valid (wrong data type or out of the valid range)
   • The Route List Name is not unique; it already exists in the system
   • The selected list entry no longer exists (has been deleted by another user)
   • A selected Route Group is a duplicate within the Route List
   • A Route Group Priority is not unique within the Route List
   • The maximum number of Route Lists (2000) already exists in the system