Editing Egress Throttle Groups

Use this task to edit Egress Throttle Groups.

When the Diameter > Configuration > Egress Throttle Groups [Edit] page opens, the columns are initially populated with the current configuration of the selected Egress Throttle Group.

The existing Egress Throttle Groups Name cannot be changed.

Changes can be made to an Egress Throttle Group configuration irrespective of the Operational Status of the associated Peer Connections.

Use this GUI page to change configuration sets and set the Egress Throttling Control Scope.

Egress Throttle Groups fields are described in Diameter Egress Throttle Groups elements.

Click Diameter > Configuration > Egress Throttle Groups.
Select the Egress Throttle Groups to be edited and click Edit.
Update the relevant fields.
An entry in a list can be removed by selecting the entry in the list and clicking the X to the right of the list.
Click:
- OK to save the changes and return to the Diameter > Configuration > Egress Throttle Groups page.
- Apply to save the changes and remain on this page.
- Cancel to return to the Diameter > Configuration > Egress Throttle Groups page without saving any changes.
The following conditions exist:
- You can only edit Peer Nodes or Connections whose Dynamic attribute is NO for inclusion in an Egress Throttle Group.
- Peer Nodes or Connections created by the Dynamic Peer Discovery feature cannot be included by any Egress Throttle Group instance.
If OK or Apply is clicked and any of the following conditions exist, then an error message appears:
- An attempt is made to remove the Rate Limiting Egress Throttling by removing the check from the corresponding Egress Throttlings check box for an Egress Throttle Group for which the Rate Limiting Admin State is set to Enabled.
- An attempt is made to remove Pending Transaction Egress Throttling by removing the check from the corresponding Egress Throttlings check box for an Egress Throttle Group for which the Pending Transaction Limiting Admin State is set to Enabled.