Adding an Application Route Table

Use this task to create a new Application Route Table. The fields are described in Diameter Application Route Tables elements.

1. Click Diameter > Configuration > Application Route Tables.
2. Click Insert.
3. Enter a unique name for the Application Route Table in the Application Route Table Name field.
4. Click OK, Apply, or Cancel.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • Any required field is empty; no value was entered or selected
   • The entry in any field in not valid (wrong data type or out of the valid range)
   • The Application Route Table Name is not unique; it already exists in the system
   • Adding this Application Route Table would cause the maximum number of Application Route Tables (500) allowed in the system to be exceeded
   • Adding this Application Route Table would cause the maximum number of Application Routing Rules (10000) allowed in the system to be exceeded

   After an Application Route Table is added, Application Routing Rules can be defined for it. See Application Routing Rules configuration.