Adding Egress Throttle Lists

Use this task to create new Egress Throttle Lists.

Egress Throttle Lists fields are described in Diameter Egress Throttle Lists elements.

1. Click Diameter > Configuration > Egress Throttle List > Egress Throttle Lists..
2. Click Insert.
3. Enter a unique name for the Egress Throttle List in the Egress Throttle List Name field.
4. Select a Site Name.
5. Select a Egress Throttle Group.
6. Set a Connection Failure Percent Reduction value.
7. Select a Rate Limiting Configuration Set.
8. Select a Pending Transaction Limiting Configuration Set.
9. Click:
   • OK to save the changes and return to the Diameter > Configuration > Egress Throttle List > Egress Throttle Lists page.
   • Apply to save the changes and remain on this page.
   • Cancel to return to the Diameter > Configuration > Egress Throttle List > Egress Throttle Lists page without saving any changes.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • The maximum number of Egress Throttle Lists have already been created.
   • There is no Egress Throttle Group in the network element corresponding to the Egress Throttle List to be added.
   • Any required fields are left empty.
   • An Egress Throttle List is configured with duplicate Peers or Connections.
   • An Egress Throttle List is configured with a Egress Throttle Group already configured as a member in any Egress Throttle List.