Editing a Peer Routing Rule

Use this task to edit a Peer Routing Rule in a Peer Route Table.

The Rule Name cannot be changed.

1. Click Diameter > Configuration > Peer Route Tables.
2. Select the Peer Route Table which contains the Peer Routing Rule you want to edit and click View/Edit Rules.
3. Select the Peer Routing Rule you want to edit, then click Edit.
4. Update the relevant fields.
   For more information about each field see Peer Routing Rule configuration elements and Peer Routing Rule operators.
5. Click:
   • OK to save the data and return to Viewing Rules for Peer Route Table: {Peer Route Table Name} page.
   • Apply to save the data and remain on this page.
   • Cancel to return to the Viewing Rules for Peer Route Table: {Peer Route Table Name} page without saving any changes.
   The following condition exists:

   • Peer Route Rules are always statically configured; no statically configured instance can refer to a dependent GUI element that was added to the configuration as a result of Dynamic Peer Discovery.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • If you attempt to insert or update a Peer Route Rule instance and the specified Route List whose Dynamic attribute value is YES.
   • Any required field is empty (no entry was made)
   • Any field is not valid or is out of range
   • The selected Peer Routing Rule no longer exists (was deleted by another user)
   • The selected Route List no longer exists (was deleted by another user)
   • The Rule is similar to an already existing Rule (the same attributes except for Rule Name and Priority)