Editing a Rate Limiting Configuration Set

Use this task to edit an existing Rate Limiting Configuration Set.

Note:

This GUI page is available from the SOAM and NOAM menu.

When the Rate Limiting Configuration Sets page opens, the fields are populated with the currently configured values.

The Rate LimitingConfiguration Set Name cannot be edited.

The fields are described in Rate Limiting Configuration Sets elements.

1. Click Diameter > Configuration > Configuration Sets > Rate Limiting Configuration Sets on the SOAM or Diameter > Configuration > Egress Throttle List > -Rate Limiting Configuration Sets on the NOAM.
2. Select the Rate Limiting Configuration Set you want to edit.
3. Click Edit.
4. Update the relevant fields.
5. Click:
   • OK to save the changes and return to the Rate Limiting Configuration Sets page.
   • Apply to save the changes and remain on this page.
   • Cancel to return to the Rate Limiting Configuration Sets page without saving any changes.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • The selected Rate Limiting Configuration Set no longer exists; it has been deleted by another user.
   • Any field is empty (no value was entered) .
   • The value in any field is not valid or is out of range.