Enabling All Traffic Throttle Groups

Use the following steps to enable TTGs that are displayed as result of the application of a filter. The list includes TTGs configured at the local SOAM, as well as Shared TTGs configured at other SOAM server groups that are referred to by one or more Route Lists configured at the local SOAM. If a filter is applied, then all TTGs that meet the filter requirements and that are currently disabled are enabled. If no filter is applied, then all currently disabled TTGs are enabled.

Note:

When a TTG's Administrative State is Disabled, the TTG's Current Loss Percent value is ignored when making routing decisions.

To enable and disable individual and multiple TTGs, shared TTGs must be included.

Note:

Shared TTGs cannot be enabled or disabled on another DSR (the GUI page buttons are inactive for prohibited actions).

If you select one or more rows that are associated with remote TTGs, Enable and Disable are greyed out. Enable and Disable are active only when the selected row or rows are associated with locally-defined TTGs.

Note:

Enable All and DisableAll are active regardless of the selected row state. If you select Enable All or DisableAll, then a window prompts you to enable or disable all locally configured TTGs, and a message indicates TTGs configured at other sites are not enabled or disabled.

1. Click Diameter > Maintenance > Traffic Throttle Groups. The Administrative State defines whether the TTG is active and can be applied to routing.
2. Optionally, click Filter and add up to four filters to limit the number of TTGs displayed. Click Go to apply the filter.
3. Click Enable All.
   A confirmation box appears to prompt you to enable or disable all locally configured TTGs, and a note displays to indicate TTGs configured at other sites are not enabled/disabled.
4. Click OK.
   The TTGs are enabled.

   If any of the selected TTGs no longer exist (they have been deleted by another user), an error message is displayed, but any selected TTGs that do exist are enabled.