Adding an MME/SGSN Topology Hiding Configuration Set

Use this task to create a new MME/SGSN Topology Hiding Configuration Set.

For more information about the fields, see Diameter MME/SGSN Topology Hiding Configuration Set elements.

1. Click Diameter > Configuration > Topology Hiding > MME/SGSN Topology Hiding Configuration Sets.
2. Click Insert.

   Note:

   If the maximum number of Configuration Sets allowed in the system (500) has been configured, then the MME/SGSN Topology Hiding Configuration Sets page does not open.
3. Enter a unique name for the Configuration Set in the MME/SGSN Topology Hiding Configuration Set Name field.
4. Enter values for the Actual Hostname and associated Pseudo Hostnames in the appropriate fields.
5. Complete the optional fields as desired.
6. Click:
   • OK to save the changes and return to the MME/SGSN Topology Hiding Configuration Sets page.
   • Apply to save the changes and remain on this page.
   • Cancel to return to the MME/SGSN Topology Hiding Configuration Sets page without saving any changes.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • Any required field is empty (no value was entered).
   • The value in any field is not valid or is out of range.
   • The MME/SGSN Topology Hiding Configuration Set Name is not unique; it already exists in the system.