When the Diameter > Configuration > Peer Node Groups [Edit] page opens, the fields are initially populated with the current values for the selected Peer Node Group.
Select the Peer Node Group you want to edit, then click Edit.
Note:
The Peer Node Group Name field is read-only on this page.
Update the relevant fields.
For more information about each field, see Table 3-17.
Click OK, Apply, or Cancel.
The following conditions exist:
You can only specify Peer Nodes whose Dynamic attribute is NO to be selected for inclusion in a Peer Node Group.
Peer Nodes created by the Dynamic Peer Discovery feature cannot be included by any Peer Node Group instance.
Peer Route Groups are always statically configured; no statically configured instance can refer to a dependent GUI element that was added to the configuration as a result of Dynamic Peer Discovery.
