Diameter Reroute On Answer

Using Reroute On Answer, you can configure rerouting scenarios based on the Application ID and Result-Code AVP values in Answer messages. If these values match the configured order pair of Application ID and Result-Code AVP value, the message is rerouted to another available Peer Node from the Route Group selected during the routing process.

You can perform these tasks on an Active System OAM (SOAM).

If there are no additional available Peer Nodes in the selected Route Group, or the maximum number of transmits has been met, then reroute is not attempted and the Answer is sent back to the originator.

On the Diameter > Configuration > Reroute on Answer page, you can perform the following actions:

• Filter the list to display only the desired entries.
• Sort the list by column in ascending or descending order by clicking the column heading. The default order is by Answer Result Code-AVP Value in ascending ASCII order.

• Click Insert.

  On the Diameter > Configuration > Reroute on Answer [Insert] page, you can add a new entry.

  The Diameter > Configuration > Reroute on Answer [Insert] does not open if the maximum number of Reroute on Answer entries (1000) already exists in the system.

• Select a Reroute on Answer entry and click Delete to delete the selected entry.