Editing a Path Topology Hiding Configuration Set

Use this task to edit an existing Path Topology Hiding Configuration Set.

When the Path Topology Hiding Configuration Sets page opens, the fields are populated with the currently configured values.

The Path Topology Hiding Configuration Set Name cannot be edited.

1. Click Diameter > Configuration > Topology Hiding > Path Topology Hiding Configuration Sets.
2. Select the Path Topology Hiding Configuration Set you want to edit.
3. Click Edit.
4. Update the relevant fields.
   For information about each field, see Diameter Topology Hiding Path Topology Hiding Configuration Set elements.
5. Click:
   • OK to save the changes and return to the Path Topology Hiding Configuration Sets page.
   • Apply to save the changes and remain on this page.
   • Cancel to return to the Path Topology Hiding Configuration Sets page without saving any changes.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • The selected Path Topology Hiding Configuration Set no longer exists; it has been deleted by another user.
   • Any required field is empty (no value was entered).
   • The value in any field is not valid or is out of range.