Adding DNS Sets

Use this task to create a new DNS Set.

The fields are described in Peer Discovery DNS Sets elements.

1. Click Diameter > Configuration > Peer Discovery > DNS Sets.
2. Click Insert.
3. Enter a unique name in the DNS Set Name field.
4. Select or enter the element values.
5. Click:
   • OK to save the new DNS Set name and return to the DNS Sets page.

     Note:

     This assumes all validation checks pass.
   • Apply to save the new DNS Set name and remain on this page.

     Note:

     This assumes all validation checks pass.
   • Cancel to return to the DNS Sets page without saving any changes.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • Any validation checks fail.
   • Any required field is empty (no value was entered).
   • The value in any field is not valid or is out of range.
   • The DNS Set Name is not unique; it already exists in the system.
   • The maximum number of DNS Sets already exists in the system.
   • The secondary IP address duplicates the primary IP address.
   • The pair of IP addresses (primary/secondary) duplicates the pair already defined for another DNS Set.

     Note:

     Exchanging the primary and secondary IP addresses does not constitute a unique DNS set.