Adding an entity

Follow these steps to add a new entity. Note that if you are adding a transparent entity, the field sets (when used), base field set, and definition being used in the entity must first be defined.

You can only perform this task when logged into the Active Primary NOAMP.

1. Select UDR > Subscriber Entity Configuration > Entity.
   The Entity page appears.
2. Click Insert.
   The Entity [Insert] page appears.
3. Enter a unique Entity Name to associate with the entity.
4. Select the Entity Type from the pulldown menu. See Entity elements for more information on each field.
5. If an entity type of Transparent is selected, specify the type of Transparent Entity Definition.
6. Check mark Pooled if this is a pooled entity.
7. Perform one of the following:
   • Click OK to save the permissions and return to the Entity page.
   • Click Apply to save the permissions and remain on the Insert page.
   • Click Cancel to return to the Entity page without saving the changes.
   If OK or Apply is clicked and any of the following exist, an error message appears:

   • Any required field is empty; no value was entered or selected
   • The entry in any field is not valid (wrong data type or out of the valid range)
   • The Entity Name is not unique; it already exists in the entity list