Adding an interface entity map

Follow these steps to add a new interface entity map. You can only perform this task when logged into the Active Primary NOAMP.

Note:

At least one entity must exist before an interface entity map can be created.

1. Select UDR > Subscriber Entity Configuration > Interface Entity Map.
   The Interface Entity Map page appears.
2. Click Insert.
3. Enter an Interface Entity Name to map to a specific type of interface and entity. If needed, the same Interface Entity Name can be used for more than one Interface Name. See Interface Entity elements for more information on each field.
4. Select a type of interface from the Interface Name pulldown list.
5. Select an existing entity name to associate with this interface from the Entity Name pulldown list.
6. Perform one of the following:
   • Click OK to save the permissions and return to the Interface Entity Map page.
   • Click Cancel to return to the Interface Entity Map page without saving the changes.
   If OK is clicked and any of the following exist, an error message appears:

   • Any required field is empty; no value was entered or selected
   • The entry in any field is not valid (wrong data type or out of the valid range)
   • The interface entity name is not unique; it already exists in the interface entity map list