Adding a definition

Use this procedure to add an entity definition and to associate one or more base field sets with it.

You can only perform this task when logged into the Active Primary NOAMP.

1. Select UDR > Subscriber Entity Configuration > Transparent Entity > Definition.
   The Definition page appears.
2. Click Insert.
3. Enter a unique Transparent Entity Definition Name to associate with the definition.
4. Checkmark Allow Reset if a reset can be performed for this entity definition.
5. Click Add Version for each base field set to associate with this entity definition.
6. From the Base Field Set Name dropdown list, select an existing base field set to associate with this entity definition. Note that at least one base field set must be associated with a definition before you can save the new definition record.

   Note:

   The base field set info that appears here is for display purposes only. See Base Field Set elements for more information on each field.
7. Once all needed fields have been added, perform one of the following:
   • Click OK to save the permissions and return to the Definition page.
   • Click Cancel to return to the Definition page without saving the changes.
   If OK is clicked and any of the following exist, an error message appears:

   • Any required field is empty; no value was entered or selected
   • The entry in any field is not valid (wrong data type or out of the valid range)
   • The transparent entity definition name is not unique; it already exists in the base field set list