Editing Command Log Export Options

Use this procedure to define parameters for the command log export, including defining the location where the log file will be written.

You can only perform this task when logged into the active primary NOAMP server. Note that you must have permission to edit this page. Permission groups are defined on the Main Menu > Administration > Access Control > Groups page.

1. Select UDR > Configuration > Command Log Export Options.
   The Command Log Export Options page appears.
2. Enter the IP address of the server where the log file is to be exported.
3. Enter the Username to be used for logging into the server.
4. Click SSH Key Exchange to enter the remote server password.
   A pop-up window appears.
5. Enter the remote server password and click Submit.
   The password is accepted and the window closes. This step needs to be completed only on initial setup or if the password changes.
6. Enter the directory where the log is to be stored on the remote server in Remote Command Log Export Directory.
7. Click to check mark Remote Command Log Export Enabled to enable the export process. If not checked, the export process is turned off.
8. Click Apply.
   If field validations succeed, the changes are saved and you remain on the same page. A successful update message appears. Changes take affect immediately.

   If the page contains any values that are not valid or are out of range, an error message appears.