Configuring E1/T1 parameters on vSTP MP

The Adax driver provides configuration file to update or enable the E1 or T1 connection parameters. QCX configuration file is located in /usr/net/Adax/qcx/ folder and the filename is qcx_conf.0.

Perform the following steps to do the configuration:

1. Login to vSTP -MP.

2. Change user as root with the following command:

   sudo su 
   

3. Open the qcx_conf.0 file.

    vim/usr/net/Adax/qcx/qcx_conf.0

   Note:

   If qcx_conf.0 file is not available, use following command to create qcx_conf.0 file from existing default configuration file.

   cp /usr/net/Adax/qcx/qcx_conf.0.hdc   /usr/net/Adax/qcx/qcx_conf.0
   

4. Update the E1 or T1 trunc type selection, Framing, Encoding scheme and Adax board clocking source selection as per deployment requirement.
   1. Set Trunc type E1 or T1:

      TRUNK_TYPE T1

   2. Trunk configuration:

      trunk <n> [parameters]
      trunk 0 ICLK 
      

5. Apply updated parameters using following command:

   /usr/net/Adax/qcx/qcx_conf -r -f /usr/net/Adax/qcx/qcx_conf.0 
   

6. Verify trunc /port status:

   cd  /usr/net/Adax/qcx
       ./qcxtest  -d hdcx
   

   Sample Output:

   qcxtest> status 0