- Diameter User Guide
- Configuring Diameter
- Diameter Route Groups
- Adding a Route Group
Adding a Route Group
Use this task to create a new Route Group.
- Click Diameter, and then Configuration, and then Route Groups.
- Click Insert.
- Enter a unique name for the Route Group in the Route Group Name field.
- Enable or disable traffic measurements in a route group by setting Traffic Measurement.
- Select the Type option for the entries included in the Route Group (Peer Nodes or Connections).
- Select the Peer Node, or Peer Node and Connection,
and enter the Provisioned Capacity field for this Route Group entry.
- Select a Peer Node from the Peer Node list.
- If the Connection Route Group option is selected for the Type field, then select a Connection assigned to the selected Peer Node from the Connection list.
- Enter the Provisioned Capacity for the selected Peer Node or Connection.
- Perform one of the following actions:
- If you want to add another Peer Node, Connection, and Provisioned Capacity entry to the Route Group, click Add and repeat step 6 for this next entry. Up to 512 entries can be provisioned for Connection Route Groups.
- If you do not want to add another entry, continue with step 8.
- Click
OK,
Apply, or
Cancel.
If OK or Apply is clicked and any of the following conditions exist, then an error message appears:
- Any required field is empty; no value was entered or selected
- The entry in any field in not valid (wrong data type or out of the valid range)
- The Route Group Name is not unique; it already exists in the system
- The selected list entry no longer exists (has been deleted by another user)
- The selected Peer Node is a duplicate within the Route Group
- The selected Connection is a duplicate within the Route Group for the same Peer Node
- The maximum number of Route Groups (6000) already exists in the system
The following conditions exist:- You can only assign Peer Nodes whose Dynamic attribute is NO to a Route Group of either type (Peer Node or Connection). Peer Nodes created via Dynamic Peer Discovery cannot be assigned to any statically-created Route Group.
- Peer Nodes created by the Dynamic Peer Discovery cannot be assigned to any statically-created Route Group.
- You can only allow Connections whose Dynamic attribute is NO to a Route Group of type Connection Route Group.
- Connections created by the Dynamic Peer Discovery feature may not be assigned to any statically-created Connection Route Group.