Diameter Diagnostics Tool
The Diagnostics Tool provides the capability to test Mediation Rule Templates that are in Test or Active state before they are subjected to live traffic in the network.
The Rule Templates are tested for a message that is injected into a connection that is set to Test Mode. A connection can be set to Test Mode only when it is created; an existing non-test connection cannot be changed into a test connection. A maximum of two test connections can exist in the system at one time.
All incoming messages on a test connection are marked as TestMode messages. When Diagnose Start is clicked on the page, TestMode messages are sent on a test connection that is selected, in Test Mode, and not Disabled.
At various trace points, the Diagnostics Tool logs the Rules that are applied, actions taken, and other diagnostic information on a test message that is injected into the system. Reports are provided that are based on the logs. Logging begins when Diagnose Start is clicked. The test can be stopped by clicking Diagnose Stop on the Maintenance Connection page.
Use this task to generate Diagnostics Tool reports from the test logs.