- Diameter User Guide
- Configuring Diameter
- Connections
- Editing a Connection
Editing a Connection
Use this task to edit an existing Connection.
- Verify the Connection to be edited is in the Disabled Admin State. See how to disable a connection in Disabling Connections.
- Click Diameter, and then Configuration, and then Connections.
- Select the Connection you want to edit.
- Click Edit.The edit page does not open if any of the following conditions exist:
- The selected Connection no longer exists.
- The Connection is not in the Disabled Admin state.
- Update the relevant fields.
See the Connection configuration elements description in Diameter Connection Configuration Elements. The Connection Name cannot be edited.
Note:
Uncheck the Test Mode checkbox to change from test connection to normal connection. You cannot reverse this action.Selecting the X at the end of a field clears the field. You can enter or select another value.
- Click OK, Apply, or Cancel.The following conditions exist:
- Any request for a list of Connections does not include any dynamically created Connection instances.
- Dynamic Peer Discovery can insert a connection instance whose Dynamic attribute is set to YES only.
- Dynamic Peer Discovery software can delete a Connection instance whose Dynamic attribute is set to YES only.
- If you attempt to edit a Connection whose Dynamic attribute set to NO, the Edit page only allows Peer Nodes and CEX Configuration Sets whose own Dynamic attribute set to NO the assigned Connection.
- If you attempt to edit a Connection whose Dynamic attribute set to YES, the Edit page only allows CEX Configuration Sets whose own Dynamic attribute set to NO the assigned Connection. A Connection whose Dynamic attribute set to YES or NO the assigned Connection.
- If you attempt to edit a Connection whose Dynamic attribute set to YES, the selection options for Connection Mode does not include Responder Only.
- Use the Enabling Connections procedure to enable the edited Connection.