2 DSR Features and Enhancements

This section provides a high-level overview of DSR features that may impact OAM interfaces and activities.

For a list of all features, refer to DSR Release Notes.

For additional information about various features, refer to the DSR Feature Guide.

Note:

For information about upgrade planning and required procedures before the upgrade, refer to the DSR Software Upgrade Guide.
The following table lists the features and enhancements that are introduced in this release.

Table 2-1 DSR Features and Enhancements

Features / Enhancements Name Description Scope
vSTP UDR connection redundancy feature POR 33883528

Prior to this release, if there is one Connection Group on vSTP NO with default priority set to 10, there was no provision to configure one interface as the priority route and another interface as the secondary (when the primary interface fails).

This feature provides redundancy between local site and remote site for Mobile Number Portability (MNP), where the priorities can be set using the the following three parameters provided in connection group for UDR lookup on vSTP NO GUI.
  • STPSvcGroup=30 (default value) indicates highest priority
  • STPSvcBackGroup=20 indicates a lesser priority
  • STPSvcSpareGroup=10 indicates a much lesser priority

For more information, see Oracle Communications Diameter Signaling Router Mobile Number Portability User Guide.

New feature
vSTP ITUI-S/ITUN-S support for MTP Screening feature POR 32948876

Starting with this release, vSTP uses the TCAP Opcode Tag Based Routing to find Operation Code Tag in all supported ITU TCAP messages except ABORT. If messages have Opcode Tag value anything other than Local(0x02) or Global(0x06), then it is considered as Invalid.

For more information, see Oracle Communications Diameter Signaling Router vSTP User Guide.

New feature