1. DSR Software Upgrade Guide
  2. Workaround to Resolve Device Deployment Failed Alarm

A.19 Workaround to Resolve Device Deployment Failed Alarm

This procedure resolves the device deployment failed alarm i.e. 10054. If this procedure fails, it is recommended to contact My Oracle Support (MOS) and ask for assistance.

A.19 NOAMP VIP GUI: Log In

  1. Open the web browser and enter the following URL:

    http://<Primary_NOAM_VIP_IP_Address>

  2. Log in to the NOAM GUI as the guiadmin user.

A.19 NOAMP VIP GUI: Identify Server(s) and Interface(s) with Alarm

Navigate to current alarm details and identify the server and interface where the 10054 - Device Deployment Failed alarm is displayed.
  1. Navigate to Alarms & Events, then View Active.
  2. Look for the 10054 alarm and make a list of the server(s) and interface(s).

A.19 NOAMP VIP GUI: Corrective Action for Alarm 10054

Interfaces like XMI and IMI are in locked state and do not allow editing as a corrective action. For XMI and IMI interfaces, first unlock the interface and for other interfaces skip steps 1 to 4 below.
  1. Navigate to Configuration, then Networking, and then Networks, select the respective “Network element” tab used for the server configuration.
  2. Click the Network Name row.
  3. Click Unlock. Click the checkbox to confirm it and click OK.
  4. To unlock the network for the particular device, navigate to Configuration, then Networking, and then Devices.
  5. Click the Server tab from the list in task 2 in this procedure.
  6. Select each interface row one by one for which alarm is showing and click Edit.
  7. Click OK.

    Note:

    Give some time to the system to auto correct the condition to clear the alarm. Once this step is done, lock the network back again which were unlocked above.

    For XMI and IMI interfaces, lock the interface back, for other interfaces skip 1 to 4 below.

  8. To lock the network for a specific device, navigate to Configuration, then Networking, and then Networks, select the respective Network element tab used for the server configuration.
  9. Click the Network Name row.
  10. Click Lock. Click the checkbox to confirm it and click OK.