1. Operations, Administration, and Maintenance Guide
  2. Configuration
  3. DSCP
  4. Port DSCP
  5. Insert a Port DSCP

3.7.2.2 Insert a Port DSCP

Use the following procedure for inserting a Port DSCP.

  1. Click Configuration, and then DSCP, and then Port DSCP.
  2. Remain on the tab for Entire Network or select a server group (but not a specific server for the interface).
  3. Select the server for the interface, or alternatively if a server group is selected, create the interface on all servers in the server group by selecting the Entire Server Group tab.
  4. Click Insert.
  5. Enter a valid Port value. A valid value is an integer between 1 and 65535, inclusive.
  6. Enter a valid DSCP value. A valid value is an integer between 0 and 63, inclusive.
  7. Select TCP or SCTP protocol from the list.
  8. Click OK to submit the information and return to the DSCP page, or click Apply to submit the information and continue entering additional data.