1. DSR BareMetal to Cloud Migration Guide
  2. Migration
  3. New Hardware and Existing IP Addresses
  4. Accessing XMI IP of DSR

4.3.2 Accessing XMI IP of DSR

Perform the following procedure to access and configure XMI IP of new vDSR 9.0.1 VM.
  1. Assign XMI IP to new vDSR 9.0.1 VM.
    • To configure netmask and XMI IP address values, run the following command:
      sudo /usr/TKLC/plat/bin/netAdm set --onboot=yes --netmask=<netmask> --device=eth0 --address=<IP address>
      where, <netmask> indicates netmask of vDSR 9.0.1

      <IP Address> indicates the IP address of vDSR 9.0.1

    Note:

    For further information on accessing XMI IP, refer to DSR Installation on OL8 and KVM and Software Installation Procedure sections in DSR Cloud Installation Guide.