6.3.1 ENUM ACLs

ENUM ACLs allow user to allow or block IPs from accessing the ENUM feature.

Select the VENUM, and then Configuration, and then Enum ACLs page. The page displays the elements on the ENUM ACLs View and Insert pages.

Table 6-9 Enum ACLs Elements

Element	Description	Data Input Notes
IP Address	IPv4 or IPv6 addresses which are to be allowed or blocked for ENUM feature. This is a mandatory field.	Valid IPv6 and IPv4 addresses
Prefix	Specifies number of bits in netmask.	Allowed values are 1-32 for IPv4 32,40,48,56,64 or 96 for IPv6
Filter	Specifies whether the configured IP is to be allowed or blocked. Blocked filter takes precedence over Allowed, if an IP falls in both ranges. This is a mandatory field.

You can perform add or delete tasks on VENUMConfigurationEnum ACLs page.

Adding Enum ACL

Perform the following steps to configure a new Enum ACL:

1. Click Insert.
2. Enter the applicable values.
3. Click OK, Apply, or Cancel

Deleting Enum ACL

Use the following procedure to delete a Enum ACL.

Note:

A Enum ACL will only be deleted if all delete validation checks pass.

1. Select the Enum ACL to be deleted.
2. Click Delete.
3. Click OK or Cancel.