3.1.3.4 Inserting a Route

Routes cannot be created which use management networks (those configured after installation and designated in the Network listing in blue italic text). This ensures continued access to the GUI via the management networks.

Following are the steps to Insert a Route:

1. Click Configuration, and then Networking, and then Routes.
2. Using the tabs, navigate to the target server group or server.
3. Click Insert.
4. Select a Route Type.
   For more information about Route Type, or any field on this page, see Routes Insert Fields.
5. Select a Device.
6. Enter a Destination.

   Note:

   This step is required only if the Route Type is Net or Host. The field is disabled if the Route Type is Default.
7. Enter the Netmask.

   Note:

   This step is required only if the Route Type is Net. The field is disabled if the Route Type is Default or Host.
8. Enter the Gateway IP.
9. Click OK to submit the information and return to the Route page, or click Apply to submit the information and continue entering additional data.