2.21.2 Adding an Application Route Table

Perform the following procedure to create a new Application Route Table:

1. Click Diameter, Configuration, and Application Route Table.
2. Click Insert.
3. Enter a unique name for the Application Route Table in the Application Route Table Name field.
4. Click OK, Apply, or Cancel.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • Any required field is empty, no value was entered or selected.
   • The entry in any field in not valid (wrong data type or out of the valid range).
   • The Application Route Table Name is not unique, it already exists in the system.
   • Adding this Application Route Table would cause the maximum number of Application Route Tables (500) allowed in the system to be exceeded.
   • Adding this Application Route Table would cause the maximum number of Application Routing Rules (65000) allowed in the system to be exceeded.
   • Application Routing Rules is defined in Application Route Table after its created. See Application Routing Rules Configuration.