3.5.8 Ending Diagnosis on a Test Connection

Use the following steps to end diagnosis on a test connection.

1. Click Diameter, and then Maintenance, and then Connections.
2. Select a single connection with the following conditions:
   • Admin State is Enabled
   • Test Mode is YES.
   • PDUs to Diagnose is greater than 0.
3. Click Diagnose End.
4. Click OK on the confirmation screen to stop the diagnosis on the selected test connection.
   The PDUs to Diagnose value is set to 0.

   If the selected connection no longer exists (it was deleted by another user), an error message is displayed and the Diameter, and then Maintenance, and then Connections page is refreshed.