Complete these tasks to configure disk devices for use with Oracle Automatic Storage Management (Oracle ASM).

1. If necessary, install the disks that you intend to use for the disk group and restart the system.
2. To ensure that the disks are available, enter the following command:

   # /usr/sbin/lsdev -Cc disk

   The output from this command is similar to the following:

   hdisk0 Available 1A-09-00-8,0  16 Bit LVD SCSI Disk Drive
   hdisk1 Available 1A-09-00-9,0  16 Bit LVD SCSI Disk Drive
   hdisk2 Available 17-08-L       SSA Logical Disk Drive

3. If a disk is not listed as available, then configure the new disks:

   # /usr/sbin/cfgmgr

4. Enter the following command on any node to identify the device names for the physical disks that you want to use:

   # /usr/sbin/lspv | grep -i none

   This command displays information similar to the following for each disk that is not configured in a volume group:

   hdisk2     0000078752249812   None

   In this example, hdisk2 is the device name of the disk and 0000078752249812 is the physical volume ID (PVID). The disks that you want to use may have a PVID, but they must not belong to a volume group.

5. Enter commands similar to the following to clear the PVID from each disk device that you want to use:

   # /usr/sbin/chdev -l hdiskn -a pv=clear

6. Enter commands similar to the following to change the owner, group, and permissions on the character file for each disk that you want to add to the disk group:

   # chown -R grid:asmadmin /dev/rhdiskn
   # chmod 660 /dev/rhdiskn

   Note:

   If you are using a multi-pathing disk driver with Automatic Storage Management, then ensure that you set the permissions only on the correct logical device name for the disk.