Verifying the Enterprise Server Installation Using PORTTEST

Note: When running PORTTEST after installing the Enterprise Server, the test returns a failure message. This is because it is not able to access the F0902 table at this time, (the format of the F0902 table changes during the Table Conversion Workbench). Ignore any errors relating to accessing the F0902 table, (for example, Select all on table F0902 failed - rcode=0). Once the Workbench tasks are all complete, and the Enterprise Server is configured, rerun PORTTEST.

To verify the Enterprise Server installation using PORTTEST:

1. Log on to the IBM i Enterprise Server as ONEWORLD (or other Release 9.2 user).

2. On Current Release 9.2 Versions, select the version of Release 9.2 that you want to use and press Enter.

3. To verify that Release 9.2 is installed correctly on the Enterprise Server, enter these command:

   GO JDEOW\A98OWMNU

4. On the A98OWMNU menu, select selection 4 to run PORTTEST.

   This program initializes a user and an environment. The program selects records from the F0902 table, which appear as messages on your screen. If messages indicating your selections do not appear, review the jde.log file. You should log on to each environment that you installed using JDE as the user and JDE as the password.

   Note: If you are running PORTTEST prior to running Table Conversions, it will fail half-way through because the F0009 and F0010 are not in the correct format.

Tip: If PORTTEST fails to run, refer to Using the PORTTEST Checklist for diagnostic assistance.